Freedom 411atv Owner's Manual & Wiring Instructions

"Protect Yourself And Your Investment"
O O O O O WNER'S MANU WNER'S MANU WNER'S MANU
WNER'S MANU WNER'S MANUAL
WIRING INSTR WIRING INSTR
WIRING INSTR WIRING INSTRUCTIONS WIRING INSTR
MODEL: MODEL:
MODEL: 411 MODEL: MODEL:
COPYRIGHT: OMEGA RESEARCH & DEVELOPMENT 1997
Operating Instructions
Arming The Alarm:
The Alarm Can Be Armed From Transmitter At Any Time. To arm the alarm system,
after you exit the vehicle, close all of the doors and press the large transmitter button
once. The alarm will respond with one siren chirp, the parking lights will flash once, and
the LED Status Light will flash fast. If an optional doorlock interface (model DM-1) was
installed, the doors will also lock. Five seconds after the arming confirmation chirp, the
LED Status Light will flash slow, confirming that the alarm is fully armed.
Disarming The Alarm:
Whenever the alarm is in an armed state the LED Status Light will be flashing slow.
To disarm the alarm, press the large transmitter button once again. The alarm will respond
with two siren chirps, the parking lights will flash twice. If the alarm was triggered while
you were away, the disarming confirmation will change to four chirps, the parking lights
will flash four times. If the optional DM-1 doorlock interface was installed, the doors will
also unlock upon disarming.
Triggering The Alarm:
Once armed, any entry or shock to the vehicle will instantly trigger the alarm. Once
triggered, the siren will sound and the exterior lights will flash for 60 seconds, unless you
disarm the alarm sooner with the transmitter. If all protected entries are secure at the end
of 60 seconds, the alarm will stop and automatically rearm itself. If any further entry
AL AL
AL AL
& & & & &
UCTIONS UCTIONS
UCTIONS UCTIONS
A A A A A TV TV TV
411 411 TV TV
411 411
Page - 3 Continued Next Page
Table
Arming The Alarm ............................................................................................................................................ 3
Disarming The Alarm ....................................................................................................................................... 3
Triggering The Alarm .................................................................................................................................... 3-4
Remote Panic Operation ................................................................................................................................... 4
Automatic Transmitter Verification TM ........................................................................................................... 4-5
TM
Code Jumping ................................................................................................................................................ 6
Using The Transmitter To Turn On And Off The Confirmation Chirps ....................................................... 5-6
Using The Transmitter To Adjust The Dual Zone Shock Sensor ..................................................................... 6
Current Sensing (Green Wire Loop) ................................................................................................................. 7
Three Minute Current Sensing Delay (White Wire Loop) ................................................................................ 7
Prewarn Feature ............................................................................................................................................. 7-8
Self Diagnosis ................................................................................................................................................... 8
Mounting The Main Control/Siren Unit ........................................................................................................... 9
Wiring Diagram Overview .............................................................................................................................. 10
Short Black Ground Wire ................................................................................................................................ 11
Red Constant 12 Volt Positive Wire .......................................................................................................... 11-12
Long Black Antenna Wire .............................................................................................................................. 12
Blue Negative Instant Trigger Wire ........................................................................................................... 12-14
Orange Grounded Output While Armed Wire ........................................................................................... 15-16
Diagram For Starter Disable Diagram ............................................................................................................ 16
White Flashing Parking Light Output Wire ............................................................................................... 17-19
Pink LED Status Light Wire ...................................................................................................................... 20-21
Programming The Alarm Control Module To The Transmitter ................................................................ 22-23
Operating A Second Vehicle's Alarm ............................................................................................................. 23
Sometimes You Have To Transmit Close To The Vehicle ............................................................................. 23
Limited Lifetime Warranty .............................................................................................................. Back Cover
attempt is made, the alarm will trigger again and repeat the process. During the 60 sec- ond
triggered cycle, you may use the transmitter to disarm the alarm, rather than waiting for it
to reset itself. Remember, once the alarm triggers, the disarming confirmation is four
chirps and four parking light flashes.
Remote Panic Operation:
In the event of attack or assault, or any time you feel threatened or in need of assistance,
you can use the transmitter to trigger the alarm as a possible means of getting help or
diverting the attacker's attention. Pressing and holding the large transmitter button for 2
seconds will trigger the alarm, which will sound the siren and flash the parking lights for
60 seconds. At 60 seconds, the alarm will automatically reset itself to the armed mode, or,
you may use the transmitter to turn off this feature, which will also disarm the alarm. The
panic feature may be used at any time - while the alarm is armed or disarmed, and regardless
of whether the ignition switch is turned on or off. If desired, a single pole, double throw
switch may be added to the alarm's Red constant power wire as a means of disarming the
alarm system if the transmitter is lost, damaged, or if its battery becomes exhausted. This
optional switch must be mounted in a concealed, but accessible location.
Automatic Transmitter Verification
For a period of 20 seconds after the alarm is disarmed by the transmitter, the LED Status
Indicator will flash to indicate the number of transmitters programmed to operate your
security system. For example: two flashes and a pause indicate that only two transmitters
are coded to operate your system. In the event the LED Status Indicator flashes a total of
stored transmitter codes different from the number of transmitters you have
Of Contents
TM
:
Page - 4