Control Panel; Glass Surfaces; Knob; Painted Surfaces - GE JRP 28 Owner's Manual

Molded rib
Spring clip
Clear groove
in stem

Control Panel

It's a good idea to wipe the control
panel after each use. Clean with mild
soap and water or vinegar and water,
rinse with clean water and polish dry
with a soft cloth.

Knob

The control knob (lower oven only) may be
removed for easier cleaning.
Before removing the knob for cleaning,
please note that the knob is in the OFF
position. When replacing the knob,
check the OFF position to insure proper
placement.

Painted Surfaces

Clean with soap and water or a vinegar
and water solution.

Glass Surfaces

To clean the outside glass finish,
use a glass cleaner. Rinse and polish
with a dry cloth.

Stainless Steel Surfaces

Do not use a steel-wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water, a stainless steel
cleaner such as Kleen King
all-purpose liquid or spray cleaner.
Always scrub in the direction of the
grain. Rinse thoroughly with a sponge
or cloth and clean water. Dry with a soft,
clean cloth.
Do not use abrasive cleansers, strong
liquid cleansers, plastic scouring pads or
oven cleansers on the control panel—they
will damage the finish. A 50/50 solution of
vinegar and hot water works well.
Wash the knob in soap and water or
a vinegar and hot water solution but
do not soak.
The knob stem is D shaped. Install the
flat of the shaft to the flat of the knob.
Do not use commercial oven cleaners,
cleansing powders, steel wool or harsh
abrasives on any painted surface.
Do not allow the water or cleaner
to run down inside the oven door
while cleaning.
(on some models)
After cleaning, use a stainless-steel polish,
such as Stainless Steel Magic
Copper and Stainless Steel Cleaner
Wenol All Purpose Metal Polish
the product instructions for cleaning the
® or an
stainless-steel surface.
www.GEAppliances.com
® , Revere
® or
® . Follow
21