Kyosho Mini-Z Racer MR-03N RM Type Instruction Sheet

Before beginning assembly, please read these instructions thoroughly.
For MINI-Z Racer MR-03N RM Type / MR-015 RM Type
VeilSide S2000 Millennium
Tools : Must be prepared.
1
Preparation of Chassis
Motor mounting position
Rear Mount Type (RM Type)
Front Body Mount
2 x 5mm TP
TP Screw
2
Chassis
2
Body
MZN110-T01
*Adhesive for plastic *Cutter Knife.
Assemble the chassis as shown below.
Replace the front body mount
with the one included in the set.
2x5mm
Caution : Do not screw-in
excessively.
Front body mount.
Painting should be done before assembling.
White Body Set (Non Decoration)
*Nippers
Adjustment of Wheelbase / Front Tread
Wheelbase (M)
Receiver Antenna
<
< Only for 27MHz >
Caution : Do not screw-in
excessively.
Antenna Cord
For painting. use plastic model paints.
Wind Shield
Side Body Mount (L)
INSTRUCTION SHEET
+
*A Phillips Screwdriver
(Precision type or a small sized)
90mm
Narrow
Bend the receiver antenna as shown below.
>
2x6mm
2mm
23.5mm
Attach each part as required.
Side Body Mount (R)
R
THE FINEST RADIO CONTROL MODELS
No.MZN110
+
Receiver Antenna