GE PVM2070 Installation Instructions Manual page 17

B5. ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
Roll the blower unit 90° so that fan blade
3
openings are facing the front of the microwave.
Before Rolling
Back of
Microwave
4
Gently slip the wire through the gap between the
two tabs on the top of the blower so the wire is
behind the tabs.
Before Rerouting
5 Rotate blower unit counterclockwise 180°.
Before Rotation
Back of
Microwave
6 Place the blower unit back into the opening.
AFTER: Fan Blade
Openings Facing Back
End B
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not pinched.
NOTE: The blower unit exhaust
openings should match exhaust openings
on rear of microwave oven.
Installation Instructions
After Rolling
Back of
Microwave
After Rerouting
After Rotation
Back of
Microwave
End A
7 Guide the wire down into the blower opening
so it rests securely in front of the blower.
8
Secure the blower unit to the microwave with
the screw from Step 1.
9
Replace the blower plate in the same position
as before with the screw.
10
Attach the exhaust adaptor to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Guide
17
Blower Plate
Back of
Microwave
Blower Motor
Screw
Adaptor
Back of
Microwave
Guide