Seat; Shock Absorber Assembly - Yamaha PW80(A) Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Seat

To remove the seat
Remove the nuts, and then pull the seat
off.
4
1
1. Nut
To install the seat
1. Insert the projection on the front of
the seat into the seat holder as
shown.
EAU41140
1
1. Seat holder
2. Projection
2. Place the seat in the original posi-
tion, and then tighten the nuts.
TIP
Make sure that the seat is properly se-
cured before riding.

Shock absorber assembly

2
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.
G
G
G
G
4-7
WARNING
Do not tamper with or attempt to
open the cylinder assembly.
Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.
Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.
Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
absorber assembly to a Yamaha
dealer for any service.
EAU46021
EWA10221