Table of Contents
Advertisement
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt GE bulb (WB02X4235)
available from your GE supplier.
I
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent. You
may add about 1 tablespoon of
ammonia to the water, providing it
does not touch the filters or enamel
surfaces because ammonia tends to
darken metal. Wash the smoke and
spatter shield with a solution of
warm water and detergent.
The Exhamt
Feature
SMOKE & SPA~ER
SHIELD
The exhaust hood feature
microwave oven is equipped with
two metal filters which collect
grease. When the fan is operated,
air is drawn up through the filters
and is then discharged through the
provided venting to the outside.
The hood also has a light for
illuminating the counter space.
When NIGHT LIGHT pad is
touched, the hood light operates
at a lower intensity for use as
a night light.
To remove grease filter, grasp the
"finger ring" on the filter and slide
to the rear. Then pull filter downward
and to the front. The filter will
drop out.
To replace grease filter, slide the
filter in the frame slot on the back
of the opening.
Pull filter upward and to the front
to lock into place.
To clean grease filter, soak, then
agitate filter in a solution of hot
water and detergent. Don't use
ammonia or other alkali because it
on
your
will darken metal. Light brushing
can be used to remove embedded
dirt. Rinse, shake and remove
moisture before replacing. Filters
should be cleaned at least once a
month.
Never operate your hood without
the filter in place. In situations
where flaming might occur on
surfaces below hood, filter will
retard entry of flames into the unit.
GROUNDING
INSTRUCTIONS
This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This-appliance is equipped with a
power cord having a grounding
wire with a grounding plug. The
that is properly installed and
grounded. (Fig. 1)
WARNING–Improper
use of the grounding plug can result
in
Consult a qualified electrician or
service technician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
Where a standard two-prong wall
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded three-prong
wall receptacle.
Do not under any circumstance
cut or remove the third @round)
prong from the power cord.
Do not use an adapter plug with
this appliance.
Do not use an extension cord with
this appliance.
29
a risk of electric ;hock.
INSURE PROPER
GROUND EXISTS
BEFORE USE
Fig. 1
Advertisement
Table of Contents
