GE Spacemaker JVM150J Use And Care Manual page 30

Use This Woblem Solver
PROBLEM
OVEN WILL N~
COME ON
CONTROL PANEL
LIGHTED, YET OVEN
WILL N~ ST~T
FOODS ARE EITHER
OVERCOOKED OR
UNDERCOOKED
ON DISPLAY
"Error" APPEARS
ON DISPLAY
Steam or vapor escaping from
around the door.
Light reflection around door or
outer case.
If you need more help... call, toll free: GE Answer Center@ /800.6262000/ consumer information service
POSSIBLE CAUSE AND REMEDY
circuit breaker,
Make sure 3-prong plug on oven is fully inserted into wdl receptacle.
Door not securely closed.
START must be touched afier entering cooking SelWtiOn.
Make sure you have entered cooking time after touching TIME COOK I & II.
CLEAR/OFF was touch~
Make sure you have entered a temperature after touching TEMP COOK/HOLD.
Make sure you entered a code number after touching
Cooking times may vary because of starting food temperature, food density or amount
of foods in oven. Touch TIME COOK I & H and additiond cooking time for completion.
Check cookbook or recipe for instructions.
more than one food item. Check cookbook time recommendations.
Dish not completely covered as directed during Auto Cook.
previous
time in Auto Cook finction.
Cooking Control Guide.
Roast functions. Check cookbook for specific instructions.
be detected.
. Dimming oven light and change
in blower sound
operating at power levels other
than high.
Dull thumping sound while oven
is operating.
breaker tripped.
Reset
cooking
when using Temp C~WHold or Auto
the door was opened before
might be noticed while using your
may occur while
microwave oven. It's similar to the
interference caused by other small
appliances and does not indicate a
problem with
30
Replace fuse or reset
touched to cancel it.
not
START.
program
AUTO COOK, AU~ ROAST,
lessening the cooking
Cook.
could
Some TV-Radio interference
your oven.