HP 3PAR StoreServ 7200 2-node Manual page 8

◦
The HP 3PAR storage system setup is verified, the storage system is powered on, and the
LEDs are functioning correctly.
◦
Either the physical
an IP address; or the virtual Service Processor (VSP) is installed and connected, and you
have determined the temporary IP address.
Make sure you have:
◦
Administrative access to the Windows host systems you are configuring
If you are planning to configure a remote host system (a machine other than the machine
into which you inserted the SmartStart media), you must be able to use the same ID and
password to gain administrator access to both the system running SmartStart (the local
host) and the remote host.
◦
Rights to configure storage
To configure storage, your user account on the HP 3PAR storage system must be assigned
either a Super or Edit role, or be granted these rights: host_create, vv_create, and
vlun_create.
◦
HP 3PAR storage system and Service Processor information necessary for initialization
and configuration
For more information, see your completed Storage System Software Installation Checklist
from the HP 3PAR StoreServ 7000 Site Planning Manual.
Service Processor information:
–
–
–
–
–
–
NOTE:
characters in length and can consist of alphanumeric characters and the following special
characters: period (.), plus (+), dash(-), equal (=), and forward slash (/).
HP 3PAR StoreServ Storage system information:
–
–
–
–
–
–
8 Prepare to Configure
Service Processor
The Service Processor IP address, subnet mask, and gateway IP address
For more information on determining the temporary IP address and assigning the
permanent IP address, see the HP 3PAR StoreServ 7000 Storage Installation Guide.
Hostname to assign
DNS settings (if applicable)
Proxy server settings (if applicable)
New password to assign to the username for the two system setup wizards (setupusr)
New password to assign to the username for the Service Processor (3parcust)
Passwords for setupusr and 3parcust usernames must be between 7 and 32
Storage system serial number
This 7-digit number is located on the back of your HP 3PAR StoreServ Storage system
next to the power switch for the node enclosure power cooling module (PCM1), and
begins with 16 (e.g., 1624635).
Storage system name
IP address (IPv4 only)
Subnet mask
Gateway IP address
New password to assign to the username for the storage system (3paradm)
is installed and powered on, and you have assigned
"Locating the Serial Number" (page 14)