Using Your Iron - GE 106800 Owner's Manual

840094500 Ev01 12/17/01 8:48 AM Page 4

Using Your Iron

To Dry Iron
1. Plug iron into outlet.
2. Set the Adjustable Steam Switch
To Steam Iron
1. Unplug iron. Fill Removable Reservoir
according to directions. Replace
Reservoir.
2. Plug iron into outlet.
3. Turn the Temperature Control Dial
To Remove, Fill, and Replace Reservoir
NOTE: The reservoir can be filled in place or removed for filling.
1. Unplug iron. Set the Adjustable
Steam Switch to O (Dry Iron).
2. Press and hold release button and
4
3. Turn Temperature Control Dial
to O (the Dry
Iron position)
or empty water
from reservoir.
4. To turn iron Off, turn Temperature
Control Dial to Off and unplug iron.
4. Allow two minutes for the iron to
5. To turn iron off, set Adjustable Steam
to desired fabric
6. Empty water from the iron following
setting in the
steam range. Set
the Adjustable
Water
Steam Switch to
Please use ordinary tap water. If you
the recommended
have extremely hard water, alternate
steam level. See
between tap water and distilled water
"Fabric Setting
for use in the iron.
Chart" on page 3.
3. Slide open reservoir fill opening
cover. Slowly pour in 4 ounces of
water. Close cover.
4. Firmly place reservoir in position and
pull straight up
on reservoir.
Use caution and
do not let your
hand touch the
hot soleplate.
to desired
temperature.
Allow two
minutes for iron
to reach desired
temperature.
reach desired temperature.
Switch to O (Dry Iron). Turn the
Temperature Control Dial to Off.
Unplug iron.
directions in "Caring for Your Iron."
push until it snaps back into place.