REPLACING THE OVEN LIGHTS
WARNING: Ensure the appliance is switched off before replacing the lamp/s to avoid
the possibility of electric shock.
■
Let the oven cavity and the heating elements to cool down.
■
Switch off the electrical supply.
LEFT LAMP (BOTTOM MAIN OVEN ONLY)
■
Remove the left wire rack and the side catalytic panel by unscrewing the
fixing screws (see chapter USE AND CARE at page 14).
■
Press down from the top the protective cover "A" (fig. 17) and remove it by
rotating on the lower side.
IMPORTANT: never use screwdrivers or other utensils to remove the cover "A". This
could damage the enamel of the oven or the lampholder. Operate only by hands.
■
Replace the halogen lamp "B" with a new one suitable for high temperatures having
the following specifications: 220-240V or 230-240V, 50 Hz and same power (check
watt power as stamped in the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never replace the bulb with bare hands; contamination
from your fingers can cause premature failure. Always use a clean cloth or gloves.
■
Refit the protective cover "A" operating in reverse order.
ATTENTION: the notch in the inner edge of the cover must be oriented toward the lamp.
■
Assemble the side catalytic panel and the left wire rack.
TOP RIGHT LAMP (BOTH OVENS):
■
Remove the protective cover "C" (fig. 17).
■
Replace the halogen lamp "B" with a new one
suitable for high temperatures having the fol-
lowing specifications 220-240V or 230-240V,
50 Hz and same power (check watt power as
stamped in the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never replace the bulb with
bare hands; contamination from your fingers can cause
premature failure. Always use a clean cloth or gloves.
Refit the protective cover C.
■
NOTE: Oven bulb replacement is not covered by your guarantee.
A
Figure 17
30
1
2
A
B
WRONG
CORRECT
A
C
B