Installing The Battery; Charging The Battery - Seculine ZIGView S2 User Manual

Before Using This Product

Installing the Battery

Load a battery pack into the camera
to fully charge it.
1. Detach the battery cover.
2. Pay attention to the plus and minus sides
before installing battery on the product.
3. Attach carefully the battery cover on the product.
4. Wrong installing may cause permanent
damage on the product.

Charging the Battery

Charge the battery fully with the provided battery charger after opening
the package.
1. After inserting the battery, connect the AC adapter
tightly to the main body.
2. It takes about 2 hours to fully charge the battery,
this may vary depending on charging
conditions. Time is increased if the product
is turned on during charging.
3. The charging lamp lights red
during charging, a full charge
the light is green.
4. Remember to connect the adapter
to the main body tightly.
Incomplete connection may disturb the charging process.
5. Disconnect the adapter from the main body after changing battery.
□ Repetitive charging/discharging may degrade the battery performance
over time.
8
<Open the cover> <Check Polarity>
<Install battery>
<Close the cover>