Configuring The Kt-400 Ethernet Four-Door Controller With The Kt-Finder; Configuring With Kt-Finder - Kantech Ethernet Four-Door Controller KT-400 Installation Manual

Configuring the KT-400 Ethernet Four-Door Controller with the KT-Finder

The KT-Finder is an application used to configure the KT-400 over the local area network (LAN) or the wide area
It doesn't require any installation.
network (WAN).
Important: The KT-Finder application is:
C:\Program Files\Kantech\Server_xE\Bin, or
•
on the EntraPass CD-ROM, or
•
• available as a free download from http://www.kantech.com
1. Quit all EntraPass applications.
2. Make sure the KT-400 is in Factory Default DHCP mode. See Table 3 on page 29.
3. Start the KT-Finder.
Note: If you try to run the KT-Finder while running EntraPass, you will get an error message similar to this.
4. Select KT-400 from the Device menu.
5. Enter the MAC address of the KT-400 then click on Connect.
6. When the KT-400 is found, the configuration page will be displayed.
KT-400 Ethernet Four-Door Controller Installation Manual
DN1726-0811 33