Philips GC7600 series User Manual page 13

Problem Possible cause
The iron leaves a The surface to be ironed
shine or an imprint was uneven, for instance
on the garment. because you were ironing
over a seam or a fold in the
garment.
The ironing board Steam has condensed on
cover becomes the ironing board cover
wet or water after a long ironing session.
droplets come out
of the soleplate.
You may have an ironing
board that is not designed
to cope with the high steam
rate of the steam generator.
There is too much The default setting of the
steam coming out iron is the OptimalTemp
of the iron. setting. In this setting the
iron provides a high steam
output.
Solution
Perfect Care is safe on all garments. The shine or
imprint is not permanent and will disappear when
you wash the garment. Avoid ironing over seams or
folds or you can place a cotton cloth over the area
to be ironed to avoid imprints.
Replace the ironing board cover if the foam material
has worn out. You can also add an extra layer of felt
material under the ironing board cover to prevent
condensation on the ironing board.
Put an extra layer of felt material under the ironing
board cover to prevent condensation on the ironing
board.
Activate the ECO mode to iron with a lower
steam output. See section 'Energy saving' in this user
manual.
This iron has been approved by The Woolmark Company Pty Ltd for
the ironing of wool only products provided that the garments are ironed
according to the instructions on the garment label and those issued by the
manufacturer of this iron. R1101. In United Kingdom, Eire, HongKong and
India, the Woolmark trademark is a Certification trademark.
ENgLIsh
13