Advertisement
MW
650 |
MW
800
User Manual
Installation
• Using the template provided, trace the
installation location with a pencil. You can do
this by holding the template in your preferred
location and tracing around it. Use a spirit
level to ensure the template is straight and
plumb. This is the exact cutout size
[fi gures 1-3].
6
FIGURE 1
Use the template provided along with a
Level to set out the cut out hole.
FIGURE 3
Remove template to show cutting guides.
User Manual
MW Series
High-Performance In-Wall Speakers
• Carefully cut the hole with the appropriate
cutting tool for your wall material. Start the
hole by drilling a hole inside of your tracing
(with the drill-bit touching the line). Use this
hole to insert the saw or knife and begin
cutting [fi gure 4].
FIGURE
2
M
Mark out the template using a permanent
Mark out the template using a permanent
marker.
FIGURE 4
Using an appropriate tool, cut out the
marked area.
• Once you have cut the hole, fi sh your
previously positioned wiring out of the hole
and connect the speaker [fi gure 6]. Follow
the hook-up directions included with your
receiver.
FIGURE 5
Y
You should now have
You should now have
the space to insert
the speaker
s
speaker
peaker
peaker.
.
FIGURE 6
Fish your previo
F
Fish your previo
usly positioned wir
usly positioned wiring out
usly positioned wiring out
of the hole ready to connect the speaker.
MW
650 |
MW
800
User Manual
Strip 12 mm of insulation from each of the
two conductors of the wire to expose the bare
metal and twist each of the conductors into a
single un-frayed strand (so you have two un-
frayed strands). Note that one of the terminals
on the rear of each speaker is red (+) and the
other is black (-).
Ensure you connect the wire from the red
terminal (+) of your amplifi er, or receiver, to
the red terminal (+) on your speaker and make
sure the black terminal (-) of your amplifi er,
or receiver, to the black terminal (-) on your
speaker [fi gure 7]. Most wire has some
indicator (such as colour-coding, ribbing or
writing) on one of the two conductors to help
you maintain consistency.
FIGURE 7
Ensure connection to the correct terminals.
Connect by pushing down on the terminal.
MW Series
User Manual
High-Performance In-Wall Speakers
7
Advertisement
