Operating Your Refrigerator; Temperature Control; Making Ice Cubes - Avanti FF8Y Instruction Manual

Deluxe frost free

Hide thumbs Also See for FF8Y:

Instruction manual (20 pages)

Table Of Contents

Table of Contents

FF8Y/FF8YSS/FF12Y-¿ „ ﬁ 00.6.20 4:31 PM ˘ ` 10

Freezer Temperature Control

MIN

MED

MAX

WINTER

* Setting the Temperature Control

• To control the internal temperature, adjust the control dial according to the ambient temperature or

purpose of use.

• The first time you turn the unit on, set the temperature control to "MAX".

• The range of the temperature control is from position "MIN" the warmest to "WINTER" the coldest. After

24 to 48 hours, adjust the temperature control to the setting that best suits your needs. The setting of

"MED" should be correct for home or office refrigerator use.

"Winter" Position: Select the "WINTER" Position when the temperature in the area where the

appliance is located is colder than 10˚C or 50˚F. This enables the freezer section to operate properly.

NOTE:

• If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before restarting the unit.

If you attempt to restart before this time delay, the refrigerator will not start.

The freezer contains an ice cube tray with a special device enabling you to get the cubes out the tray

more easily.

* Making Ice Cubes

• Remove the ice cube tray.

• Fill the tray with water up to the maximum water level marked on the rear of the tray.

• Slide the tray back into the holder, taking care not to spill the water.

• Wait until the ice cubes are formed.

* Removing the Ice Cubes

• Make sure that the ice cube storage bin is in place under the ice cube tray.

If not, slide it into place.

• Twist on of the levers flrmly in the clockwise direction until the tray twists slightly.

• The ice cubes fall into the storage bin.

• Repeat for the other half of the tray, if necessary.