Table of Contents
Advertisement
OPERATING YOUR REFRIGERATOR
>
Setting the Temperature Control
• To control the internal temperature, adjust the control dial according to the ambient
temperature or purpose of use.
• The first time you turn the unit on, set the temperature control to "5"
• The range of the temperature control is from position" 1" the warmest to "5" the coldest. After
24 to 48 hours, adjust the temperature control to the setting that best suites your needs. The
setting of "3" should be correct for home or office refrigerator use.
NOTE:
■
If the unit is unplugged, power lost, or turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the refrigerator will not
start.
>
Use of the Ice Cube Trays
•
For your ice requirements, fill approximately
Va
of the tray after washing it.
•
To release the ice cubes, hold the tray upside down and twist slightly at both ends until the
pieces of ice fall.
CARE AND MAINTENANCE
>
Defrosting Your Refrigerator
Defrost the refrigerator when the frost accumulated on the evaporator is about 5mm (1/5 inch)
thick. Set the thermostat dial to "0". Remove items. Defrosting usually takes a few hours. After
defrosting, empty water from drip tray and return the thermostat dial to the desired position. To
defrost ouickly remove all foods from the refrigerator and leave the door open. Never use a knife
or othei metal instrument to scrap ice/frost from the evaporator. (Refer to picture)
>■
Reversal And Installation Of The Refrigerator Door
•
Remove both screw-type leveling legs (7).
•
Remove the three screws (8) that hold the lower right hinge (4), save hinge for later use.
•
Remove door from upper pin (1), lift it and place it on a padded surface to prevent
scratching it,
•
Using a flat screwdriver remove right upper pin and transfer it to the same location on the
opposite side.
•
Remove the pin cap (2) from the left side of the upper frame of the door, and then transfer
it to the same location on the opposite side.
•
Remove inner plug (3) from upper frame of door and transfer it to the uncovered hole on
7
Advertisement
Table of Contents
