Changeover Nozzle; Cleaning Tips; Washing Brush - Craftsman 559.741710 Owner's Manual

CHANGEOVER NOZZLE

• It is possible to work with a high pressure or a low
pressure jet. The symbol of the choosen jet form is
on the upper side of the changeover nozzle.
• Changing the jet form is only possible with the
trigger gun closed.
- Release trigger.
- Turn changeover nozzle 90° to alter pressure of
the water jet.
Note: Detergents can only be syphoned at low
pressure.

WASHING BRUSH

Use the washing brush to clean at low pressure to
remove dirt and road film. The brush can be used
with or without detergent.
To attach:
- Push the washing brush into the trigger gun
against the spring tension and turn it as far as the
stop.
- The washing brush must lock into position.
O P E R A T I O N

CLEANING TIPS

- For best results, the high-pressure lance should be
held between 6" - 24" away from the surface being
cleaned. Holding the wand too close to the surface
may damage the object being cleaned. On the
other hand, if the lance is too far away, optimum
cleaning results will not be achieved. it´s always
best to test the surface first to see if damage occurs
when the lance is held too close.
- When cleaning car tires, the nozzle should be held
at least 6" from the surface to avoid damage.
- Apply detergent at low pressure from the bottom
up and pressure wash at high pressure from the
top down.
- Always apply detergent to a dry surface and allow
1-3 minutes dwell time.
- To be environmentally safe,
• cleaning engines is only recommended where a
• clean facades, terraces and garden equipment
Note: With special accessories (not included)
suitable oil seperator is provided.
with the high-pressure jet alone, without cleaning
agent.
it can also be used for such jobs as
removing rust and paint, for cleaning
pipes, for pumping water and for
applying plant protection chemicals.
These items are avaiable from most
SEARS RETAIL OUTLETS.
9