Table of Contents
Advertisement
en
Cleaning the appliance
Attention!
Do not use abrasive, chloride or acidic
cleaning agents or solvents.
Do not use scouring or abrasive sponges.
The surface of the rear panel could be
damaged and corrosion could occur.
Never clean shelves and containers in
the dishwasher. The parts may warp!
Proceed as follows:
S Before cleaning: Switch off
the appliance.
S Pull out the mains plug or switch off
the fuse.
S Clean the appliance with a soft cloth,
lukewarm water and a little PH neutral
washing up liquid. The rinsing water
must not run into the light.
S Wipe the door seal with clear water only
and then wipe dry thoroughly.
S Rinsing water must not run through the
drainage hole into the evaporation area.
S After cleaning reconnect and switch on
the appliance.
Note
Regularly clean condensation channels
and drainage hole, Fig. 7/A,, with cotton
buds, etc. so that the condensation can
run out.
10
Important care information
for stainless steel
appliances
Use Chromol" cleaning agent for
cleaning stainless steel surfaces.
This cleaning agent is available on the
market under the name Chromol" or from
your customer service under
ident no. 310359 as a 500 ml spray can
or under
ident no. 166787 as a 50 ml trial can.
To prevent damage to the surfaces, under
no circumstances use abrasive sponges,
metal brushes, sharp edged implements
or scouring agents. Chemically aggressive
cleaning agents, such as defrosting
sprays, oven sprays, solvents or stain
removers must not be used either.
The stainless steel surface should be
cleaned in the direction of the grain.
Advertisement
Table of Contents
