Configurable Interfaces; Performing Initial Connection And Configuration; Establishing A Terminal Emulator Connection - Juniper NetScreen-5000 Series Installation And Configuration Manual

Configurable Interfaces

Table 7 shows the configurable interfaces available on the NetScreen-5000 Series.
Table 7: NetScreen-5000 Series Configurable Interfaces
Interface Type
Ethernet
Layer-2
Tunnel
Function

Performing Initial Connection and Configuration

To establish the first console session with the NetScreen-5000 Series system, use a
vt100 terminal emulator program through the provided RJ-45/DB9 serial port
connector.

Establishing a Terminal Emulator Connection

To establish an initial console session:
1. Plug the DB-9 end of the supplied RJ-45/DB-9 serial cable into the serial port of
2. Plug the RJ-45 end of the cable into the Console port of the NetScreen-5000
Description
ethernetn1/n2 specifies a physical Ethernet interface, denoted by an interface
module in a slot (n1) and a physical port (n2) on the module
ethernetn1/n2.n3 specifies a logical interface, denoted by an interface
module in a slot (n1), a physical port (n2) on the module, and a logical
interface number ( .n3). You create logical interfaces using the set interface
command.
vlan1 specifies the interface used for management and VPN while the
NetScreen-5000 Series system is in Transparent mode
tunnel.n specifies a tunnel interface. Use this interface for VPN traffic
mgt specifies a dedicated management interface bound to the MGT zone
ha1 and ha2 specify the names of the dedicated HA ports
your workstation. (Be sure that the DB-9 is seated properly and secured with
the screws.)
Series system. (Be sure that the RJ-45 clip snaps into the port and is seated
properly.)
Configuring the Device

Performing Initial Connection and Configuration

33