Table of Contents
Advertisement
Software Installation and
Verification
The Toshiba NetPac Wireless System software is to be used for
system setup only.
Consult the ASD PRO Software Manual for specifics on the
operation of the ASD PRO software.
Driver/Port Installation and Setup
Proper system operation requires that two components be loaded
onto the host PC: Driver information and Port information.
Note: Both components must be loaded completely.
Failure to load both components completely may
result in an unexpected motor response,
intermittent operation, or total system failure.
Follow steps
Upon completion, repeat steps
information.
1.
Place the CD that was received with the system into the CD
ROM drive.
Note: The Found New Hardware Wizard dialog box
appears when the USB Transceiver Module is
inserted at step
2.
At the Found New Hardware Wizard dialog box click
Install from a list or specific location (Advanced) and
click Next (see
NetPac Wireless System
1
through
7
below to load the driver information.
1 on pg.
Figure 1. on pg.
2
through
6
to load the port
9.
12).
11
Advertisement
Table of Contents
