Table of Contents
Advertisement
Hardware Installation and
Connections
C o n t a c t W i t h E n e r g i z e d W i r i n g
W i l l C a u s e S e v e r e I n j u r y O r
There are two types of transceiver modules used with the
7-Series ASD. The Series-2 (shown below) is used with the
7-Series ASD only and the RJ-45 type (shown on
with the 7- and 9-Series ASD.
Series-2 Transceiver Module
Installation
1.
Ensure that all system/ASD power is off and that the ASD
Power and Charge LEDs are off.
2.
Open the front door or remove the front cover (device-
specific) of the ASD to gain access to the control board of
the ASD.
3.
Remove the factory-installed
Jumper PCB from the J4
connector of the control board
(note Jumper PCB orientation in
the event that a re-installation is
required) — the Jumper PCB is
no longer required.
4.
Insert the Adapter Board
(P/N 59513) into the J4 and J5
dual in-line rows of connectors of
the control board (figure to right)
— ensure that the board is inserted with the correct
8
DANGER
L o s s O f L i f e .
page
9) is used
NetPac Wireless System
Advertisement
Table of Contents
