Yaesu Band Data - Tokyo Hy-Power HL-1.5KFX User Manual

9-3 Yaesu Band Data

Using the Yaesu band data connection cable (shown below), connect the transceiver (example,
FT-1000MP MK-V) to the HL-1.5KFX.
Turn off the AC POWER to the transceiver and the amplifier. Connect the 8 pin DIN plug to the BAND
DATA (8 pin) socket of the Yaesu transceiver. Connect the other end, the 5 pin DIN plug to the ‡ M YAESU
of 5 pin DIN socket on the rear panel of the amplifier.
Check and make sure that the transceiver is in receive mode. Power up the transceiver and then turn on
the AC POWER to the amplifier. Observe that the band indicator (LED) of the amplifier matches that of
the transceiver.
YA ES U Yaesu Ba nd D at a Ca bl e
YAESU TRANSCEIVE
ANT
BAND DA TA
(DIN 8P)
D I N PLU G 8P
R
TX G N D EXTALC
ANTA
INPUT
DI N PL UG5P
SWR/POWE
TX
YAESU BAN D D ATA CAB LE
HL-1.5KF X REAR VIEW
16
AN TENNA
R METER
ANT
YAESU
(DIN 5P)
SEND
ALC