9. Band Data Cable Connection
Connection methods with ICOM, Yaesu and Kenwood transceivers are described here in detail
respectively. This connection enables the automatic band setting of the amplifier with the band set
command from the transceiver. Four types of cable connections are explained.
9-1 ICOM DC Voltage Band Data
For your safety, please turn off the power (AC) to both the transceiver and amplifier. Connect the cable
(for ICOM DC Voltage Band Data Connection) as shown in the following illustration.
Slide the " BAND DECODE" slide switch on the rear panel toward " ICOM ". (Other side is for CI-V.)
Set the " BAND SELECT " rotary switch on the front panel to " ICOM ". Now turn on the AC to the
transceiver, and then turn the POWER switch to the amplifier on. Observe that the band indicator (LED)
of the amplifier matches that of the transceiver.
I CO M DC Volt age Band D at a Cable
ICOMTRANSCEIVER
(IC-746,-756,-7800
ANT
SEND
ALC
ACC(2) REMOTE
Note : This connection is for ICOM models of 746, 756, 7800 etc. (706MK II G & 7000 need a
special connection to the ACC socket using the ICOM supplied accessory cable assembly. See
the 706/7000 manual). IC-7700 is to be connected to CI-V terminal.
DIN PLUG 7P
etc.)
(DIN 7P)
ANTA
INPUT
SWR/POWER
TX
ICOMD C VO LTAG E BAND D AT A C AB LE ( DI N 7P • © • ¨ R
HL-1.5KFX REAR VIEW
14
RC A PLU G
ANTENNA
METER
ANT
CA• j
SEND
ALC
ICOM
(RCA )
BAND DECODE SW
SE LECT " I CO M "