Check Or Clean Your Filter; Replace The Uvc Bulb - Hunter 30846 Owner's Manual

Total air purification, permanent hepa

Hide thumbs

Table Of Contents

Table of Contents

5. If the Pre-Filter needs to be cleaned, It may be

submerged in warm soapy water to clean. Gently lift

and submerge the filter several times to clean.

6. When complete, rinse the filter with warm water and

allow to dry completely.

Note: Wet parts placed into the unit can cause damage

to the filters and or the motor of the Air Purifier.

1. Turn the Air Purifier off and disconnect from the wall.

2. Remove the rear grill on the back of the unit by

pressing the tab at the top of the unit, under the

handle and pull the rear grill outward. Figure 7.

3. Remove the Permanent HEPA Filter from the unit.

4. Check the Filter for particle build-up.

5. To clean, use a vacuum cleaner with an upholstery

brush attachment, gently run the upholstery brush

over the cleanable filter until all particles are removed

from the filter. An arrow indicating which side to clean

is present on the top of the filter. Figure 8.

Note: Filter discoloration is normal and will not be

removed by vacuuming. Do not attempt to wash the filter

as damage to the filter or Air Purifier may occur.

The UVC light should be replaced once yearly. Follow

these instructions to remove and replace the UVC bulb.

1. Unplug the unit from the wall outlet and remove the

back grill by pressing down on the top tab.

2. Remove the 2 screws holding the Photcatalytic Screen

in place and remove the screen. Figure 9.

3. Remove the 3 screws holding the UVC Guard in place

and remove it from the unit. Figure 10. & 11.

4. Grasp the bulb with your thumbs and forefingers at

the plastic top and bottom and gently roll the bulb to

the left. Figure 12.