Touch Control Panel - Hotpoint AQUALTIS AQD1170D 697 E Instructions For Installation And Use Manual

Touch control panel

WASH CYCLE
SELECTOR
knob
ON/OFF
Button with
indicator light
Button with ON/OFF indicator light: press this briefly
to switch the machine on or off. The green indicator light
indicates that the machine is switched on. To switch off
the Washer-dryer during the wash cycle, press and hold
the button for approximately 3 seconds; if the button is
pressed briefly or accidentally the machine will not switch
off. If the machine is switched off during a wash cycle, this
wash cycle will be cancelled.
WASH CYCLE SELECTOR knob: may be turned in
either direction. To select the most suitable wash cycle,
please refer to the "Table of wash cycles".
The knob will not move during the wash cycle.
M1-M2 buttons: press and hold one of the buttons to
store a cycle with your own set preferences in the memory
of the machine. To recall a previously-stored cycle, press
the corresponding button.
DRYING button : press to decrease or exclude drying;
the selected drying level or time will appear on the display
(see "How to run a wash cycle or a drying cycle").
TEMPERATURE button: press to modify or exclude
the temperature setting; the value selected will appear
on the display above (see "How to run a wash cycle or a
drying cycle").
button: press to modify or exclude the
SPIN CYCLE
spin cycle; the value selected will appear on the display
above (see "How to run a wash cycle or a drying cycle").
DELAYED START button: press to set a delayed start
for the selected wash cycle; the set delay time will appear
on the display above (see "How to run a wash cycle or a
drying cycle").
OPTION buttons: press to select the available options.
The indicator light corresponding to the selected option will
remain lit (see "How to run a wash cycle or a drying cycle").
M1
M2
DISPLAY
DRYING
button
SPIN
button
TEMPERATURE
button
OPTION
DELAYED START
buttons
button
WASH CYCLE PHASE icons: these illuminate to indicate
the progress of the wash cycle (Wash
Spin/ Drain – Drying
the cycle is complete.
START/PAUSE button with indicator light: when the
green indicator light flashes slowly, press the button to
start a wash cycle. Once the cycle has begun the indicator
light will remain lit in a fixed manner. To pause the wash
cycle, press the button again; the indicator light will flash
in an orange colour. If the "LOCK"
switched off, the door may be opened. To start the wash
cycle from the point at which it was interrupted, press the
button again.
indicator light: indicates that the porthole door is
LOCK
locked. To open the door, pause the wash cycle (see "How
to run a wash cycle or a drying cycle").
CHILD LOCK
or deactivate the CHILD LOCK, press and hold the button
for approximately 2 seconds. when the indicator light
is illuminated, the control panel is locked. This means it
is possible to prevent wash cycles from being modified
accidentally, especially where there are children in the
home.
ECO indicator light: the
altering the washing parameters, an energy saving of
at least 10% is made. Furthermore, before the machine
enters "Standby" mode, the icon will light up for a few
seconds; when the machine is switched off the estimated
energy saving will be around the 80% mark.
START/PAUSE
button
with indicator light
ECO
indicator light
CHILD LOCK
button with indicator light
LOCK
indicator light
– Rinse
). The text lights up when
indicator light is
button with indicator light: to activate
icon lights up when, after
WASH
EN
CYCLE
PHASE
icons
–
7 7