Table of Contents
Advertisement
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust
Bag and filter often. We suggest emptying the dust bag after every use.
NOTE:
When vacuuming carpet fresheners or cleaners, powder, plaster dust, or similar fine substances,
the dust bag and filter will require more frequent maintenance.
CAUTION: Turn off the switch and unplug the electrical cord before changing the dust bag or filter. Never
operate the vacuum cleaner without the dust bag or filter in place.
Emptying the Dust Bag and Installing or Cleaning the Pre-Motor Filter:
1
Open the tool box. Lift up on the dust bag
compartment lid.
2
Lift the dust bag out of compartment. While the dust
bag is out of the cleaner, check the pre-motor filter to
see if it needs to be cleaned. Pull it up out of the two
brackets holding it in place.
Dust Bag
Two
Brackets
3 To clean the pre-motor filter, you can vacuum it with
another vacuum or wash it under running water. The
filter must be completely dry before reinstalling
in the cleaner.
8
Bag
Lid
Pre-Motor Filter
4 To empty cloth dust bag, hold dust bag over a
waste container and slide the bottom clamp off
the dust bag. Shake debris into waste container.
Reposition plastic clamp at base of dust bag.
Reinstalling the Pre-Motor Filter
and Dust Bag:
1
To replace the pre-motor filter, slide it down
between the two brackets in the dust bag
compartment. Make sure the filter is pushed all
the way down to the bottom of the brackets.
Put the dust bag back in the bag compartment
2
and close the bag compartment lid.
Storage:
Store indoors in a cool, dry place. Do not expose to
rain.
Advertisement
Table of Contents
