Viper 550 ESP Installation Manual page 14

H2/2 LIGHT GREEN/BLACK (-) factory disarm output
This wire sends a negative pulse every time the remote start is activated. This can be used to pulse the disarm
wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the disarm wire as shown
in the diagrams below. This wire can also be used as a special accessory output. (See Feature Descriptions section
of this guide.)
Relay for Negative (-) Disarm Wire
H2/3 VIOLET/BLACK 200 mA (-) channel 4 output
This wire provides a (-) 200mA output whenever the transmitter button(s) controlling Channel 4 is pressed. This
output can be programmed to provide the following types of outputs (see also the Feature Menus section):
I Validity: Output that will send a signal as long as the transmission is received.
I Latched: Output that will send a signal when the Channel 4 button(s) is pressed and will continue until the
same button(s) is pressed again.
I Latched, reset with ignition: Similar to the latched output, this type of output turns on the first time the
Channel 4 button(s) is pressed and turns off the next time the same button is pressed. This type of output
additionally stops and resets whenever the ignition is turned on and then off.
I 30-second timed: Output that will send a continuous signal for 30 seconds.
I Second unlock output: This output can also be programmed to provide a second unlock pulse whenever the
disarm button is pressed within 15 seconds after disarming the system. This setting could be used to unlock
the passenger doors when installing progressive door locks, for instance.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This transis-
torized output can only supply 200 mA, and connecting directly to a solenoid, motor, or other
high-current device will cause the module to fail.
14
Relay for Positive (+) Disarm Wire
© 2000 Directed Electronics, Inc. Vista, CA