Control Panel; Control Knobs; Metal Parts; Kick Panel - GE JSP60GN Use And Care & Installation Manual

Control Panel

Wash with soap and water. Rinse with clean
water and dry with a paper towel. Do not use
scouring pads or abrasive cleaners because they
may damage the finish.

Control Knobs

The control knobs may be
removed for cleaning.
NOTE: Before removing the
knobs for cleaning, please note
that the knobs on the left side and
the knobs on the right side are in
the proper OFF position. When
replacing the knobs, check the
OFF position to insure proper
alignment.

Metal Parts

Do not use steel wool, abrasives,
ammonia or commercial oven
cleaners. To safely clean surfaces;
wash, rinse and then dry with a
soft cloth.

Kick Panel

To clean the front of the kick panel, wash with soap
and water. Rinse well. Do not use cleansing powders

Painted Surfaces

Painted surfaces include the outside oven door, sides,
control panel and drawer front. Clean these with soap
and water or a vinegar and water solution.
40
CARE AND
(continued)
To remove the knob, pull it
straight off the control shaft.
Wash the knobs in soap and water
but do not soak. Dry the knobs as
much as possible with a clean cloth.
Shake water out of the knob stem.
To
replace the knob, locate the
molded rib inside the knob stem.
Fit the molded rib of the knob stem
into the clear groove on the control
shaft and push down.
CLEANING
Glass Surfaces
To clean the outside glass
finish, use a glass cle~ner.
Rinse and polish with a
dry cloth. Do not alIow
the water or cleaner to run
down inside openings in
the glass while cleaning. ~
Cleaning Under the Range
The area under the range can be reached easily for
cleaning by lowering the bottom panel. To open, pull
down flat to the floor.
Do not use the area in this compartment for storage.
Never place combustible or flammable items inside or
near the range.
Do not use commercial oven cleaners, cleansing
powders, steel wool or harsh abrasives on any
painted surface.
—
—