GE Profile GSD4610 Owner's Manual page 9

Options
3
The light above the selected pad will be ON to indicate which OPTION has been selected.
POWER For use with heavily soiled and/or dried-on, baked-on soils. This option
PRESOAK MUST be selected PRIOR to starting the cycle. This option adds 16
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is
OFF saved. You can prop the door open after the light goes ON next to the
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time
ON to your wash cycle by 30 minutes. NOTE: Cannot be selected with
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold
RESET To change a cycle after washing starts, touch the START/RESET pad to
Start
4
Close the door until it locks into place and touch the START/RESET pad to
begin the cycle. There is a time delay between start-up and water fill so you
will not hear any wash action right away.
The cycle is complete when the light is ON next to the word CLEAN in the
STATUS display.
NOTE: The dishwasher remembers your last cycle so you don't have to
reprogram each time. When the dishwasher is loaded and door latch is
in the locked position, the control panel lights will be ON and display the
last settings you selected.
If you don't want to change any of the settings, simply touch the
START/RESET pad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically
be programmed. Make any new selections and touch the START/RESET
pad to begin the cycle.
minutes to the cycle time.
spotting on dishware. This option may be turned ON or OFF during the
wash cycle.
word CLEAN which appears in the STATUS display for faster drying.
RINSE & HOLD cycle.
inoperative. You can lock the controls to prevent any selections from being made.
Or you can lock the controls after you have started a cycle or selected DELAY
START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads
with this option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice
within 3 seconds. The light above the LOCK pad will be off.
the DELAY START pad to choose the number of hours you want to delay
the start of the cycle. The machine will count down and start automatically
at the correct time. NOTE: If you forget to lock the door a reminder signal
will beep until you do so.
cancel the cycle. After water is pumped out and motor stops, you can
reprogram and restart the dishwasher.
9