Table of Contents
Advertisement
I
NSTALLATION
1. Make sure that the power supply cord is plugged into the POWER 12V
DC jack on the base and into an AC outlet.
2. Plug the telephone line cord into the PHONE LINE jack on the base and
into a modular jack.
3. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE
for pulse (rotary) service. If you don't know which type of service you
have, check with the phone company.
4. Slide the base RINGER switch to ON if you want the unit to ring for
incoming calls. (The RINGER switch is located on the same side of the
base as the antenna.)
5. Raise the base antenna.
5
RINGER
OFF
ON
4
NOTE: Use only the Thomson 5-2430 (black)/5-2431 (white) power supply
that came with this unit. Using other adapters may damage the unit.
6
& S
ETUP
TONE PULSE
PHONE LINE
POWER DC 12V
3
Note: For convenience,
attach the headset hook
to the slots at the back
of the base. You can rest
the headset here when
you are not using it.
1
2
Advertisement
Table of Contents
