Table of Contents
Advertisement
1.
Open a door. (The H1/5 GREEN wire or the H1/7 VIOLET wire must be con-
nected.)
2.
Ignition. Turn the ignition on, then back off: (The H1/9 YELLOW wire must be
connected.)
3.
Select a Menu. Press and HOLD the Override switch: (The Override switch must
be plugged into the blue port.) After three seconds the siren will chirp once indicating
entry to the Basic Features Menu #1. If this is the menu you wish to access, release the
button and go on to Step 4. If the button is not released, you will jump to the Advanced
Features Menu #2 and the siren will chirp twice. Once you have selected the desired
menu, release the Override button and then proceed to Step 4.
4. Select a Feature. Press and release the Override switch the number of times cor-
responding to the feature you wish to change. For example, to access the third fea-
ture, press and release the switch three times. Then press the switch once more and
HOLD it. The siren will chirp the number of times equal to the step you have accessed.
5.
Program the Feature. While holding the Override switch, you can toggle the fea-
ture on and off using the remote. Pressing
Pressing
will select the two chirp setting.
(See System Features Menus section of this guide.)
N N O O T T E E : : The Override pulse count feature (2-5) and the Channel three timed output (2-9) have five possi-
ble settings each. Pressing
6.
Release the Override Switch.
Once a feature is programmed:
Other features can be programmed within the same menu.
Another menu can be selected.
The learn routine can be exited if programming is complete.
To access another feature in the same menu:
1.
Press and release the Override switch the number of times necessary to advance from the feature
you just programmed to the next one you want to program.
14
will toggle through all the two-chirp settings.
will select the one chirp setting.
Hide quick links:
Advertisement
Table of Contents
