Table of Contents
Advertisement
Troubleshooting
Your washing machine could occasionally fail to work. Before contacting the Technical Assistance Service (see " Service"),
make sure that the problem cannot be not solved easily using the following list.
Problem:
The machine does not switch on.
The wash cycle does not start.
The machine does not fill with
water or 'H20' flashes in the
display.
The machine continuously fills with
water and continually drains away
or Water left in the drum
or Stuck on wash.
The machine does not drain or spin
- (error lights flashing).
The machine does spin
The machine does not drain or spin
- 'EASY IRON' & 'START/PAUSE'
indicator lights flash.
The programme takes too long.
The Display sticks at one 'time to
end' for more than 1 Minute or the
Display changes the estimated 'Time
to End' during the programme.
The machine vibrates a lot during
the spin cycle.
Possible causes / Solutions:
and 100 cm from the floor (see "Installation").
into the machine, the drain hose must be positioned higher than the bottom of
the sink to prevent water flowing down the drain hose.
.
(see "Installation").
connected under a sink.
.
program it requires the drain phase to be started. To complete the program
temperature and if the wash load goes out of balance. This will increase the
may vary.
Polystyrene Packaging have not been removed when installing the machine.
a lower speed.
.
it is not a precise time to finish and
.
.
GB
.
13
Advertisement
Table of Contents
