Accessories
Accessories Supplied
Check that you have the Accessories and items shown
Operating
Instruction book
Clamper × 3
TMME289
Remote Control Batteries
Requires two AA batteries.
1. Pull and hold the hook, then
open the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, ¿ re or the like.
8
CD-ROM
(Operating
instructions)
AC cord
2. Insert batteries - note correct
polarity (+ and -).
-
+
Remote Control Transmitter
N2QAYB000432
Ferrite core
J0KG00000146 (Set of 2)
Use the Ferrite cores to comply with
the EMC standard. (see page 61)
3. Replace the cover.
"AA" size
+
-
Batteries for the
Remote Control
Transmitter
(AA Size × 2)