Linksys RV042 Installation Instructions Manual page 24

There are many settings that must be configured to enable VPN for a dedicated tunnel:
• Tunnel Name. The tunnel name is simply a name for this tunnel
(i.e.VPNtoGalileo)
• Local Group Setup:
o
o
o
o
o
• Remote Security group:
o
o
o
o
o
•
IPSec setup: Phase 1
• IPSec Setup: Phase 2
•
Advanced:
Local Security Gateway Type: IP Only
IP Address: This will be pre-filled in from the WAN IP address as
previously selected.
Local Security Group Type: Subnet
IP Address: The Network address assigned by Galileo. This is usually 1
less than the Router address. (i.e. 10.185.5.160)
Subnet Mask: Subnet mask provided by Galileo. (i.e.255.255.255.224)
Remote Security Gateway Type: IP Only
IP Address: This is the address of the Remote PEER provided by Galileo
(i.e. 198.151.32.16)
Remote Security group type: Subnet
IP Address: This is the address of the remote network to get to Galileo
services. This will be one of the following networks:
57.8.81.0 –
198.177.164.0 – Galileo Production Net 2
167.125.0.0 –
Subnet Mask: 255.255.255.0
Keying Mode: IKE with Preshared Key
o
Phase 1 DH group: Group 2
o
Phase 1 Encryption: 3DES
o
Phase 1 Authentication: SHA1
o
Phase 1 SA Lifetime: 86400 seconds
o
Perfect forward Secrecy: Not checked
o
Phase 2 DH group: Group 2
o
Phase 2 Encryption: 3DES
o
Phase 2 Authentication: SHA1
o
Phase 2 SA Lifetime: 28800 seconds
o
Preshared Key: Provided by Galileo as needed
o
Aggressive Mode: Checked
o
Compress (Support IP Payload Compression Protocol(IP Comp)):
o
Not Checked
Keep Alive: Checked
o
AH Hash Algorithm: Not Checked
o
Netbios Broadcast: Not Checked
o
Galileo Production Net 1
Galileo Canada Leisure Link
24