Table of Contents
Advertisement
4.5.2
Mechanical positioning
4.5.2.1
Average seek time (without command overhead, including settling)
Table 8 Mechanical positioning performance
The terms "Typical" and "Max" are used throughout this specification with the following meanings:
Typical. The average of the drive population tested at nominal environmental and voltage conditions.
Max. The maximum value measured on any one drive over the full range of the environmental and voltage
conditions. (See Section 6.2, "Environment" on page 24 and Section 6.3, "DC Power Requirements" on
page 26.)
Seek time is measured from the start of the motion of the actuator to the start of a reliable read or write
operation. "Reliable read or write" implies that error correction/recovery is not used to correct arrival
problems. The average seek time is measured as the weighted average of all possible seek combinations.
__________________________________________________
Weighted Average =
where: max
= maximum seek length
= seek length (1 to max)
n
Tn
= inward measured seek time for an n-track seek
in
= outward measured seek time for an n-track seek
Tn
out
4.5.2.2
Full stroke seek (without command overhead, including settling)
Command Type
Read
Write (Quiet Seek mode)
Table 9 Full stroke seek time
Full stroke seek is measured as the average of 1000 full stroke seeks with a random head switch from both
directions (inward and outward).
HITACHI Deskstar & CinemaStar 7K1000.B & Deskstar E7K1000 Hard Disk Drive specification
Typical (ms)
14.0
15.0
14.0
15.0
max.
(max. + 1 - n) (Tn
+ Tn
in
n=1
(max. + 1) (Tn
+ Tn
in
Typical (ms)
27.0
28.0
27.0
28.0
Max (ms)
Typical (ms)
14.7
8.5
15.7
9.5
14.7
14.0
15.7
15.0
)
out
)
out
1D
Max (ms)
Typical (ms)
30.0
15.1
31.0
16.1
30.0
27.0
31.0
28.0
13
Max (ms)
9.2
10.2
14.7
15.7
2D/3D
Max (ms)
17.7
18.7
30.0
31.0
Hide quick links:
Advertisement
Table of Contents
