Non Operating Vibration; Table 17 Random Vibration Psd Profile Break Points (Operating) - Hitachi HDS723020BLA642 Specifications

6.6 Vibration and shock
All vibration and shock measurements recorded in this section are made with a drive that has no mounting
attachments for the systems. The input power for the measurements is applied to the normal drive mounting
points.
6.6.1 Operating vibration
6.6.1.1
Random vibration (Linear)
The test is 30 minutes of random vibration using the power spectral density (PSD) levels shown below in each of
three mutually perpendicular axes. The disk drive will operate without non-recoverable errors when subjected to
the below random vibration levels.
Frequency 5 Hz
1.9 x
(m /sec )/Hz 10E–3
2 4

Table 17 Random vibration PSD profile break points (operating)

The overall RMS (root mean square) level is
6.6.1.2
Swept sine vibration (Linear)
The drive will meet the criteria shown below while operating in the specified conditions:
 No errors occur with
3-minute dwells at two major resonances
 No data loss occurs with 9.8
with 3-minute dwells at two major resonances
6.6.1.3
Random vibration (Rotational)
The drive will meet the criteria shown below while operating in the specified conditions:
 Less than 20% Performance degradation for Random Write/Read/Verify @12.5Rad/sec
6.6.2

Non operating vibration

The drive does not sustain permanent damage or loss of previously recorded data after being subjected to the
environment described below
17 Hz 45 Hz 48 Hz
1.1 x 1.1 x 7.7 x
10E–1 10E–1 10E–1
6.57 m/sec
4.9 m/sec
2 (
0.5 G) 0 to peak, 5 to 300 to 5 Hz sine wave, 0.5 oct/min sweep rate with
m/sec
2(
1 G) 0 to peak, 5 to 300 to 5 Hz sine wave, 0.5 oct/min sweep rate
Hitachi hard disk drive specifications
62 Hz 65 Hz 150 Hz
7.7 x 9.6 x 9.6 x
10E–1 10E–2 10E–2
2
(0.67 G).
39
RMS
200 Hz 500 Hz
m/sec
4.8 x 4.8 x
6.57
10E–2 10E–2
2
(10-300Hz Flat)
2