Table of Contents
Advertisement
2.14.1
Working method (Production of trousers)
30
Possible processing variants
–
Front trousers pockets with pocket bag positioned below
–
Hind trousers pockets with or without flap, with pocket bag
positioned below
Positioning method
Example: Hind trousers without flap, with pocket bag positioned below
1st step:
–
Select the pocket program on the control panel
–
Push the pocket bag under pocket bag clamp 1 and position it at
the marks 2.
As marks you can use e.g. adhesive tape attached to the fabric
sliding sheet.
2nd step:
–
Position hind trousers at the "rear positioning point" 4 and at
mark 3.
–
Touch the pedal.
The hind trousers is firmly clamped in its position by the fabric
downholder 5.
–
Smooth out the clamped hind trousers in the area of the dart.
3rd step:
–
Touch the pedal.
The feeding clamps run forward and lower onto the workpiece. A
separate lowering of the clamp halves can be programmed.
For example: the right clamp lowers and the fullness from the
trousers is manually smoothed out to the left. Then lower the left
clamp.
–
Position the piping strip 7 on the feeding clamps flush at the front
edges 8.
The alignment of the various piping types on the feeding clamps is
described more precisely in the following.
See "Positioning the piping strip".
–
Touch the pedal.
The folder 6 lowers.
–
Touch the pedal once again.
The sewing cycle starts.
Advertisement
Table of Contents
