Table of Contents
Advertisement
1
2
Changing the needles
3
Caution: Danger of injury!
Switch the main switch off.
Change the needles only with the main switch turned off.
Danger of cutting your fingers!
Do not reach into the area of the center knife 3 when changing the
needles.
–
Swing the folding station aside (see chapter 2.1)
The needles are freely accessible.
–
Loosen screw 2 and remove the needle from the needle holder 1.
–
Insert the new needle in the drill-hole of needle holder 1 as far as it
will go.
ATTENTION!
Seen from the operator's side, the hollow groove 4 of the left
needle must point to the left and the hollow groove 5 of the right
needle to the right (see sketch).
–
Tighten screw 2.
ATTENTION!
After changing over to another needle size the needle protection on the
hook has to be readjusted (see Service Instructions).
Hint:
The standard needle size of class 745-34 is Nm 100 .
4
5
15
Advertisement
Table of Contents
