Advertisement
SYSTEM COMPONENTS
This System Includes:
• Waste Xpress Unit
• 3 HP Disposer
• Disposer mount (collar or bowl)
• Syphon Breaker
• Flow Control Valve 5 GPM
(18.9 LPM)
TYPICAL INSTALLATION
Figure 1. Waste Xpress Top View
Disposer
Figure 2. Waste Xpress Typical Installation
GENERAL NOTES
Disposer
• Install the disposer per the Instruction, Care and Use manual.
• When positioning disposer ensure that the overload reset
button is accessible by end user.
• Connect cold water to either the sink bowl or end of trough.
Waste Xpress
• Install the Waste Xpress per the Instruction, Care and
Use manual.
• Position the pulper so that the front surface of the discharge
chute is recessed 3" (76.2 mm) (see Figure 1) from the front
edge of the table and that a minimum clearance of 1" (25.4 mm)
exists between the underside of the table and top of the
discharge chute (see Figure 2) for proper removal of discharge
chute, ease of cleaning and general maintenance.
• Position the pulper so that it is within 10' (3.1 m) of the
disposer outlet flange. (See Figure 2)
• Magnetic Silver Saver
• 10 gallon (37.9 liter) Waste Can
• 3" (76.2 mm) to 2" (50.8 mm) disposer waste
outlet reducer fitting
• (2) 24V Water Solenoids
• WX-101A Control Center
45˚ bend shown
(max of 4 can be used)
Syphon Breaker
Sink Bowl
WX-101A Controller
Items Supplied by Others:
• Plumbing from cold water supply to bowl or trough
• Plumbing from hot water supply to Waste Xpress
• Plumbing from disposer to Waste Xpress or
• Shut off valves
• Electrical connections
1-1/2"
(38.1 mm)
Cold Water Solenoid
Hot Water Solenoid
1-1/2" min
(38.1 mm
min)
Flow Control Valve
Shut Off Valve
(supplied
by others)
10 max
(3.1 m max)
• The Waste Xpress should be disassembled and cleaned a
minimum of once daily. Interior of cabinet and discharge chute
should be cleaned with hot soapy water. Auger, screen and
bearing bracket can be cleaned either manually with hot soapy
water or in a dishwasher.
Control Panel
• Install the WX-101A control panel per the Instruction, Care and
Use manual and in accordance to local, state and or national
electric codes.
• Position the control panel so that the front surface is recessed
1-1/2" (38.1 mm) from the front edge of the table and that a
minimum clearance of 2" (50.8 mm) exists between the underside
of the table and the top of the control panel for ease of installation
and serviceability.
• Position the WX-101A control panel so that it is within site of the
disposer and pulper.
Waste Xpress to floor sink or floor drain
Waste Xpress
(25.4 mm min)
3"
(76.2 mm)
1" min
Advertisement
