Assembly - Weslo Cadence L 290 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires your own phillips screwdriver
wrenches , and wire cutters
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
3/8" Nut (34)–4
Handrail Washer (51)–4
1. With the help of a second person, carefully raise the
Uprights (31) to the position shown. Note that the
Console Base (12) and the Right Handrail (32) are
joined to the right Upright with the Wire Harness (28); be
careful not to pull on the Wire Harness. Set the Right
Handrail on the right Upright until step 3 is completed.
Refer to the inset drawing. Position one of the Base
Legs (38) against the base of the right Upright (31) as
shown. Make sure that the Base Leg Pads (41) and the
Front Wheel (39) are in the indicated positions. Attach
the Base Leg with two 3/8" x 2" Bolts (43), two 3/8"
Washers (35), and two 3/8" Nuts (34). It may be helpful
to tip the treadmill as you insert the Bolts.
Attach the other Base Leg (41) in the same way.
2. Attach the Storage Latch (18) to the left Upright (31) with
two Screws (24). Be careful not to overtighten the
Screws.
.
1/4" x 1" Bolt (23)–4
3/8" Washer (35)–4
5
1 1/4" Screw (20)–4
Screw (24)–2
3/8" x 2" Bolt (43)–4
1
12
2
31
18
, two adjustable
28
32
31
31
34
35 38
43
34
41
39
24