Assembly - Weslo Cadence Ls10 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included allen wrench
driver , adjustable wrench
Handrail Washer (32)Ð4
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
Refer to the inset drawing. Remove the nut, bolt, and
shipping bracket from the left Upright (14).
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the
treadmill.
Next, cut the plastic tie holding the cage nut in the upper
end of Left Handrail (2).
Position the Left Handrail (2) on the left Upright (14).
Attach the lower end of the Left Handrail first. Thread
a Handrail Bolt (15) with a Handrail Washer (32) into the
lower end of the Left Handrail and the left Upright. Do not
tighten the Handrail Bolt yet.
Attach the upper end of the Left Handrail (2) to the left
Upright (14) with a Handrail Bolt (15) and Handrail
Washer (32). Do not tighten the Handrail Bolt yet.
, open end wrench
Extension Leg Screw (34)Ð2
Handrail Bolt (15)Ð4
5
and your own phillips screw-
and scissors
Latch Screw (59)Ð2
Screw (55)Ð4
34
1
41
36
41
36
34
2
15
32
14
32
15
.
Shipping
Bolt
Bracket
Nut
14
Plastic Tie
2