Replacing A Lost Key Or Remote Control - Ford Fiesta Owner's Manual

60 Keys and Remote Control

REPLACING A LOST KEY OR REMOTE CONTROL

Replacement or additional keys or remote controls can be purchased
from your authorized dealer. Your dealer can program the transmitters to
your vehicle or you may be able to program them yourself. Refer to the
Security chapter for information on programming your keys.
Reprogramming Your Remote Control
Note: You can only program an integrated keyhead transmitter. See your
authorized dealer to have an intelligent access transmitter programmed.
You must have all remote controls available before beginning this
procedure. If all remote controls are not present during programming,
the ones missing will no longer operate the vehicle.
To reprogram the remote control:
1. Turn the ignition switch from off to run four times in rapid succession
(within six seconds), with the fourth turn ending in off. If the program
mode is successfully entered, a chime will sound.
Note: If no action is taken within 10 seconds after a transmitter has
been programmed, the programming sequence ends.
2. Within 10 seconds, press any button on the transmitter to be
programmed. A chime will sound to confirm that the transmitter is
programmed. Repeat this step for each transmitter.
Note: There is no chime or any other confirmation upon exiting the
programming mode.
3. Exiting the programming mode is accomplished if one of the following
occurs:
• The ignition is turned on.
• Ten seconds have passed since entering the programming mode or
since the last transmitter was programmed.
• The maximum number (eight) of transmitters has been programmed.
2013 Fiesta (fie)
Owners Guide gf, 1st Printing
USA (fus)