Bosch UFLED Installation Manual page 16

16 en | Installation
1.
2.
3.
4.
5.
6.
7.
F.01U.123.987 | 1.0 | 2010.04
Attach the illuminator to a pan and tilt unit, wall bracket or
camera housing as required.
Connect the illuminator to a 12–24 VDC or to a 24 VAC
(±15%, 50/60 Hz) power supply.
Commission the mains supply, camera, and monitoring
control equipment.
Adjust the pan of the illuminator to match the camera's
field of view.
Loosen the bolts on each side of the unit and adjust the
vertical alignment to maximize the results; re-tighten the
bolts.
Tilt the unit downwards until the near part of required field
of view is saturated with light as viewed on the monitor.
Slowly tilt the unit upwards until the furthest part of the
required field of view is illuminated correctly on the
monitor.
Installation Manual
AEGIS UFLED
Bosch Security Systems