Advertisement
ILLUMINATION WIRING:
1. Connect the LED + spade terminal to an accessory
switched 12 volt wire. This wire should have +12V
when the ignition key is "on" and 0 volts when the
ignition key is "off". You can use a toggle switch
in line on this wire to manual turn the illumination
off if desired and this 12V+ wire must have a 5 amp
fuse in line.
2. Connect the LED - spade terminal to chassis ground.
LED +
Speaker Wire +
Due to the venter backplate, you must allow for an
additional 2" behind the subwoofer when designing
your speaker enclosure.
7
+ -
313.7mm / 12.35"
278mm / 10.84"
LED -
Speaker Wire -
Advertisement
