Related Manuals for Autotek M12D4
Summary of Contents for Autotek M12D4
- Page 2 MEAN MACHINE SERIES CAR AUDIO SUBWOOFERS Congratulations on your purchase of the new Autotek Mean Machine Series subwoofer system. The Mean Machine subwoofer series has received a progressive new look with the addition of an illuminating logo on the cone. The Mean Machine subwoofer series has made its’...
-
Page 3: Enclosure Materials
SUBWOOFER INSTALLATION AND WIRING DIRECTIONS Enclosure Materials Typically, 5/8” or 3/4” MDF (Medium Density Fiber Board) is best for most applications. 3/4” MDF is recommended. Enclosure Build Materials Connecting joints need to be glued and screwed to ensure no air escapes and joints do not separate under high pressure. Mitered and rabbet joints also help to ensure the enclosure joints are secure. - Page 5 Check out our videos of new products, events and technical tutorials at www.youtube.com/maxxsonicsusainc...
-
Page 6: Glossary Of Terms
Glossary of Terms The energy losses of relative damping (ratio of stored to dissipated energy or ratio of reactive to resistive energy). Free air resonance of driver in Hz. Qms Mechanical Q. Vas Volume of air equivalent to driver from the rest position. Cms Mechanical compliance of a loud speaker piston. - Page 8 ILLUMINATION WIRING: 1. Connect the LED + spade terminal to an accessory switched 12 volt wire. This wire should have +12V when the ignition key is “on” and 0 volts when the ignition key is “off”. You can use a toggle switch in line on this wire to manual turn the illumination off if desired and this 12V+ wire must have a 5 amp fuse in line.
- Page 9 Maxxsonics Limited Warranty As the manufacturer of Maxxsonics, MB Quart, Autotek, Crunch and Hifonics car audio products, Maxxsonics USA Inc. Warrants to the original consumer purchaser the amplifier to be free from defects in material and workmanship for one (1) Year from date of purchase.
- Page 10 PART#F0910...