About Reversing The Door - GE Profile DPSB620 Owner's Manual

About reversing the door.

16
Reversing the Door
Tools needed:
I Standard #2 I Tape-tipped
Phillips screwdriver putty knife
Open the door and remove the filler plugs opposite the hinges. With the
1
door completely open, remove the bottom screw from each hinge on the
dryer face. Insert these screws about halfway into the TOP holes, for each
hinge, on the opposite side (where you removed the filler plugs).
Apply firm pressure to get the screw started in new holes.
Loosen top screw from each hinge on the dryer face halfway. With one hand
2
holding the top of the door and the other hand holding the bottom, remove
the door from the dryer by lifting it UP and OUT.
Rotate the door 180°. Insert it on the opposite side of the opening by moving
3
the door IN and DOWN until the top hinge and the bottom hinge are resting
on the top screws inserted in step 1.
Remove the remaining screws from the side of the opening from which
4
the door was removed. With these screws secure each hinge at the bottom.
Tighten the two top screws of each hinge. Reinsert the plastic plugs on the
side from which the door was removed.