Care And Maintenance, And Trouble Shooting Guide - Danby DDR3008EE Owner's Manual

Cleaning
CAUTION:
Before attempting to clean and/
or service this unit, always disconnect the
power supply cord from the electrical power
supply/outlet.
DO NOT
1. use gasoline, benzene, paint
thinner, or any other chemicals to clean
this unit, as these substances will damage/
deform both plastic components and luster
finish.
2. Never attempt to clean the unit by pour-
ing water directly over any of the surface
areas, as this will cause deterioration of elec-
trical components and wiring insulation.
3. Use only a mild dish washing detergent,
lukewarm water and a soft cloth to wipe the
exterior surface of the unit and dry thor-
oughly.
TROUBLE SHOOTING GUIDE
Frequently, some problems are of a minor
nature and a service call may not be neces-
sary. Use this troubleshooting guide to iden-
tify possible problems you may be experi-
encing. If the unit continues to operate
improperly, call your local Danby® Service
Depot or 1-800-26-DANBY (1-800-263-2629)
for assistance.
PROBLEM
Unit will not operate.
Dehumidifying capacity
(moisture removal) low.
Relative Humidity setting not
reached after long period of
operation.
Care and Maintenance
When the dehumidifier is not being used
for long time periods, please follow these
instructions.
1. Disconnect the power cord from the
2. Empty the water tank and wipe (clean)
3. Clean air filter thoroughly
4. Re-package the unit in the original carton.
5. Store the unit upright in a dry location.
POSSIBLE CAUSE
Check power cord connection.
Check electrical outlet for blown fuse.
Check if water tank is full (empty).
Check water tank is properly installed.
Air filter is dirty and/or blocked.
Ambient room temperature too low. (below 3°C/38°F)
Poor airflow circulation / obstruction of front grill.
Relative Humidity in surrounding environment very low.
Check all doors and windows are closed.
Area/room is too large for the capacity of the
dehumidifier.
11
Storage
power supply.
thoroughly.