Bosch 400 Quick Install Manual page 3

Video Recorder 400 Series
To get the unit quickly operational, make the connections
described below and then enter the relevant data in the Quick
install menu. The Quick install menu appears the first time the
unit is started.
1. Connect the cameras to the
(automatically terminated).
2. Connect monitor A to the
(supporting 800x600, 1024x768, or 1280x1024).
3. Connect USB mouse to a port.
1. Connect monitor B to the
2. Connect up to 4 audio signals to the
(CINCH) inputs.
3. Connect the RCA (CINCH) output to the
monitor or an audio amplifier.
4. Connect up to 4 inputs (via the supplied
terminal blocks).
5. Connect up to 4 outputs (via the supplied
terminal blocks).
6. Connect a pan/tilt/zoom control unit to the
(via the supplied screw terminal block).
7. Connect to your network via the
8. Connect a "Bosch RS232 to Bi-phase converter" to the
port if required.
Switch on all connected equipment.
– Connect the power cord to the unit.
Bosch Security Systems
The Quick install menu opens the first time the unit is used. Fill
in the basic settings in the three tabs to get the unit
operational. The unit begins recording automatically when the
Quick install menu is closed.
To open the Quick install menu at any other time:
1. Press the menu
Bar.
2. Press the menu
BNC connectors
– The main menu appears on monitor A.
3. Select System, then the Configuration submenu, and
output
finally Quick install.
Use the supplied USB mouse. Alternatively, use the following
front panel keys:
BNC connector.
RCA – Use the enter
– Use the arrow
move through a menu or list.
– Use the exit
menu.
port
After bootup, the unit presents the log in screen over a quad
display. The default User ID is ADMINISTRATOR, the default
Ethernet port.
password is 000000 (six zeros).
key to bring up the System Control
key again to enter the main menu.
key to select a submenu or item.
keys to
key to go back or to switch off the
The Quick install menu contains three tabs: International,
Continuous Recording, and Network. Click the
exit the Quick install menu. Changing Quick install settings
overwrites customized settings.
Select the language for the menu from the
list.
Select a time zone from the list.
Select either a 12 or a 24 hour clock format.
Fill in the current time.
Select from three date formats which show
either the month (MM), the day (DD), or the
year (YYYY) first.
Fill in the current date.
Set the Continuous Recording Resolution, Quality, Frame rate,
Covert, and Audio for each profile in the table.
Enter a DVR name to be used in the
network.
Enable DHCP to have IP address, subnet
mask, and default gateway assigned
automatically by the network server.
The actual values are displayed.
Fill in the IP, subnet mask, and gateway
addresses when DHCP is disabled.
F.01U.137.406 | v1.0 | 2009.12
Quick install | en
button to