Pro-Form 515 Zlt Treadmill User Manual page 17

5. Follow your progress with the displays.
The far left display—
When you select the
manual mode, the matrix
will display a track that
represents 400 m (1/4
mile). As you exercise,
the indicators around
the track will appear in succession until the entire
track appears. The track will then disappear and the
indicators will again begin to appear in succession.
The lower left display—
As you exercise, this
display can show the
elapsed time and the
distance that you have
walked or run. This dis-
play will also show the incline of the treadmill each
time the incline level changes.
The lower right
display—This display
can show the approxi-
mate number of calories
that you have burned
and the speed of the
walking belt. This display also shows your heart
rate when you use the handgrip heart rate monitor
(see step 6).
The upper dis-
play—This dis-
play can show
the elapsed
time, the dis-
tance that you
have walked or run, the approximate number of
calories that you have burned, or the speed of the
walking belt. Press the Display button repeatedly
until the upper display shows the information that
you are most interested in viewing. Note: While in-
formation is shown in the upper display, the same
information will not be shown in the lower displays.
To reset the displays, press the Stop button, re-
move the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using the
handgrip heart
rate monitor, re-
move the sheets
of plastic from the
metal contacts
on the console.
In addition, make
sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and hold the metal contacts on the console.
Avoid moving your hands. When your pulse is
detected, a heart symbol in the lower right display
will flash each time your heart beats, one or two
dashes will appear, and then your heart rate will be
shown. For the most accurate heart rate reading,
continue to hold the contacts for about 15
seconds.
7. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to zero. The
incline must be at zero or you may damage the
treadmill when you fold it to the storage position.
Next, remove the key from the console and put it in a
secure place.
When you are finished using the treadmill, press the
power switch into the off position and unplug the
power cord. IMPORTANT: If you do not do this,
the treadmill's electrical components may wear
prematurely.
17
Contacts