ProForm 5.0 Crosstrainer Treadmill User Manual page 8

5. Attach the Latch Housing (73) to the left Upright
(84) with two Screws (3); start both Screws
and then tighten them. Note: Make sure that
the large hole in the Latch Housing is on the
indicated side.
Remove the knob from the Latch Pin (21). Make
sure that the collar and the spring are on the
Latch Pin. (Note: If there are two collars, place
one on each side of the spring.) Next, insert the
Latch Pin into the Latch Housing (73). Then,
tighten the knob onto the Latch Pin.
6. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see page 20).
If you purchase the optional chest pulse sensor (see
page 16), follow the steps below to install the receiver
included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated Screw (3) and the Access Door
(76) from the back side of the Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console Base (85). Hold the re-
ceiver so that the small cylinder is oriented as
shown and is facing the Console Back. Attach the re-
ceiver to the plastic posts on the Access Door (76) with
the two included small screws.
3. Make sure that no wires are pinched. Reattach the
Access Door (76) with the Screw (3). Discard the other
wires included with the receiver.
5
Knob
3
Large Hole
85
76
3
Cylinder
8
84
73
Spring
Collar
Wire
Small
Screws
Small
A
Latch
Pin